Holder sitting uneven with holes on the other side. I had purchased this paper holder at Lowes.
I removed the holder and measured the wall.
I took an old pallet board and measured out 19 inches.
I used a miter saw and made a single cut down the board.
I used my handy sander to remove the bird poop and clean it up a bit.
I then used minwax wood finish in golden oak to stain.
I applied it to one of the planks.
I applied the stain in the direction of the grain.
This shows the before and after for the stain application.
I put the holders appliance on the board.
Then I secured it in the side of the vanity.
I also had a helper throughout the process. She was more interested in the q tips.
I tightened the holder in place.
The holder now matches my 'pallet' towel holder.
The result is a happier "less hole-y" bathroom. Now to figure out how to get the monkey down.
The end result. Now...to eventually 'paint' this bathroom!